Ortho Project : Cutting and finalisation (step 6)

Cutting was quite easy, with no real difficulties. My Dremel was enough for that, I just had to follow the “tooth lign” to only keep the molding of the teeth.

Cutting following the tooth lign

Image 1 of 3


And to keep them always with me, I 3D printed a nice box !

By the way, I had to remove the last tooth of my upper jaw for two reason: my mold was not good enough on these teeth, and the aligner was too big for my box 🙂

Leave a Reply

Your email address will not be published. Required fields are marked *